Circle and Dot Pattern Laser Engraved Stainless Steel Mini Bar Fidget Spinner

  

Stainless Steel Bar Fidget Spinner. Not numbered in any way. Bearing is set in place with adhesive of some kind. The circle and dot pattern is laser engraved on the body and buttons. The sides of the spinner and buttons are engraved with line extensions to look like the circle patterns continue.

The pattern may not perfectly be centered on portions. Note this as return are not accepted. What you see is what you get, again this is all laser pattern and not a form of dama-steel. Only the pattern is similar. May have slight machining pattern variations also from the machining process.

Item is in overall good used condition and shows some signs of use. There is a circular line on the curved spinner body about halfway from the buttons up toward the spinner end. This curved line mark is on both sides of the spinner and may be from larger buttons rubbing or a variation in the laser pattern.

There is some heat discoloration from the laser pattern process on the lower portions where material is removed during the process, this allows the pattern to show better in contrast. As it is I listed this color may change and lighten.

This should be noted as it is used and the color is not evenly distributed now. May have other light surface scratches not picked up by the camera, or machine lines but hardly noticeable if there. Color and tint may vary based on device or screen used to view this listing.